Powerex Elmo Rietschle Rotary Vane Vacuum Pump Vacuum Compressor 60 Gal Tank
POWEREX ELMO RIETSCHLE ROTARY VANE VACUUM PUMP/VACUUM COMPRESSOR INDUSTRIAL 60 GALLON TANK. Powered on & off for only a few classes over a 2 week period - 15 Hours on this amazing Vacuum Pump/Vacuum Compressor. Includes the 3 rubber foot pads as seen in the 12th picture. A lubricated rotary vane pump has a series of sliding vanes attached to a rotor in the pump cylinder.
As the rotor spins, centrifugal force causes the vanes to slide outward to form a seal on the cylinder wall with oil that is injected into the pumping chamber. Air is pulled into the pump inlet which is then compressed and discharged into the exhaust box. The sealing oil is filtered and re-circulated within the pump via oil filters which eliminates 99.9% of lubricating oil from the exhaust. 29.3 hg end vacuum.
Oil flooded for lubrication and heat dissipation. Our lubricated rotary vane vacuum system is perfect for more industrial applications, like molding, packaging and printing. The tank-mounted design allows for easy maintenance, easy installation and a small system footprint. The powerex vacuum system is designed provide vacuum for applications such as laboratories, molding, packaging, printing and other similar facilities.The package shall include one or two vacuum pumps and associated equipment, one tank and one control panel. Each pump is factory piped to a common intake manifold. Vibration isolation pads for installation between the system mounting feet and the floor shall be included with the system. The vacuum pumps shall be of the rotary vane air- cooled design. Each vacuum pump shall be direct- driven through a shaft coupling by a electric motor.
Belt drives shall not be permitted. Each vacuum pump shall be air-cooled and have absolutely no water requirements. Each vacuum pump shall have an end (ultimate) vacuum of 29.3 hg (15 torr). Lubrication shall be provided by an integral, fully re- circulating oil supply that is filtered by an automotive- type, spin-on oil filter. Non-re-circulating (once- through) or partial re-circulating oil supply systems shall not be permitted. Each vacuum pump shall be capable of operation with standard 30 weight oil. The oil separation systems hall be integral and shall consist of no less than three stages of internally installed oil and smoke eliminators through which the exhaust gas stream must pass. This system shall consist of bulk separation, oil mist elimination, and smoke elimination, and shall be capable of removing 99.9+ percent of all oil and smoke particles from the exhaust gas stream. Each vacuum pump shall include a built-in, anti-suck-back valve, mounted at the pump inlet, and three sliding vanes. Each vacuum pump shall be equipped with a 10 micron inlet filter for removal of particulates. The vacuum pumps shall be mounted on vibration isolators. The system shall also include a supplementary check valve between the inlet filter and the pump. The motor is eisa compliant, continuous duty, nema rated, c-face, 460v, 3 phase, 60 hertz electrical operation.